The Story
This is a 2 pack of our white COB (Chip On Board) LED strips that come with a strip of adhesive on their back.
These are fantastically bright and are perfect for:
-Computer cases, server racks, status signal lights
-Vehicle installation under the hood, under foot wells, as dome lights, marker lights, DRLs (Daytime Running Lights) and more
-In home lighting and under cabinet lighting
-Much, much more!
SPECS:
12 VDC @ ~150mA
Approximate Dimensions:
Length: 0.52" (13.40mm)
Width: 6.7" (170.18mm)
Height: 0.084" (2.14mm)
Wire Length: 7.5" (190mm)
All dimensions are approximate and are subject to change without notice. We will do our best to keep them up to date.
PLEASE NOTE: For what ever reason, sometimes the Red and Black wires are soldered on opposite their intended polarity. So if you get a "bad strip", try hooking it up backwards.
NOTE: these strips REQUIRE ONLY 12 Volts DC. If you supply any more than 12 V, you need to add a voltage regulator OR a current limiting resistor to the circuit or you will burn the strip up due to thermal runaway. If you are using this in a vehicle, then you MUST do the above. Vehicles charge their batteries at around 13 to 14.5 volts, this is enough to destroy these strips and possibly burn them up. By our calculations, if you want to use these in a vehicle, you should get a 27 ohm resistor in at least 1/2 watt. See link below:
https://vetco.net/products/27-ohm-1-2-watt-resistor
PACK QTY: 2 Strips
Details & Craftsmanship
Every detail has been carefully considered to bring you the perfect product.
Description
This is a 2 pack of our white COB (Chip On Board) LED strips that come with a strip of adhesive on their back.
These are fantastically bright and are perfect for:
-Computer cases, server racks, status signal lights
-Vehicle installation under the hood, under foot wells, as dome lights, marker lights, DRLs (Daytime Running Lights) and more
-In home lighting and under cabinet lighting
-Much, much more!
SPECS:
12 VDC @ ~150mA
Approximate Dimensions:
Length: 0.52" (13.40mm)
Width: 6.7" (170.18mm)
Height: 0.084" (2.14mm)
Wire Length: 7.5" (190mm)
All dimensions are approximate and are subject to change without notice. We will do our best to keep them up to date.
PLEASE NOTE: For what ever reason, sometimes the Red and Black wires are soldered on opposite their intended polarity. So if you get a "bad strip", try hooking it up backwards.
NOTE: these strips REQUIRE ONLY 12 Volts DC. If you supply any more than 12 V, you need to add a voltage regulator OR a current limiting resistor to the circuit or you will burn the strip up due to thermal runaway. If you are using this in a vehicle, then you MUST do the above. Vehicles charge their batteries at around 13 to 14.5 volts, this is enough to destroy these strips and possibly burn them up. By our calculations, if you want to use these in a vehicle, you should get a 27 ohm resistor in at least 1/2 watt. See link below:
https://vetco.net/products/27-ohm-1-2-watt-resistor
PACK QTY: 2 Strips
